酒店在采購布草時，除了對織物的顏色、花型、紗織密度進行挑選外，縮水率指標同樣重要。除了產品本身的質量問題，洗滌、烘干、熨燙都會對縮水率造成影響。

In addition to selecting the color, pattern, and yarn density of the fabric, the shrinkage index is also important when purchasing linen. In addition to the quality issues of the product itself, washing, drying, and ironing can all have an impact on the shrinkage rate.

"縮水率"的正式稱呼為"水洗尺寸變化率"，是指紡織物在洗滌或浸水后收縮的百分數。

"Shrinkage rate", formally known as "wash size change rate", refers to the percentage of shrinkage of a textile fabric after washing or soaking.

縮水率=(洗滌前尺寸-洗滌后尺寸)/洗滌前尺寸×100%

Shrinkage ratio=(size before washing - size after washing)/size before washing × 100%

縮水率主要取決于不同面料之間的差異和織物結構。

The shrinkage rate mainly depends on the differences between different fabrics and the fabric structure.

通常來說，

Generally speaking,

全棉經向、緯向5%左右；

About 5% in warp and weft direction of cotton;

滌棉經向、緯向4%左右。

The warp and weft directions of polyester and cotton are about 4%.

除此以外，編織松散會比緊密型產品更易縮水。

In addition, loosely woven products tend to shrink more easily than compact products.

縮水的原因：

Reason for shrinkage:

一：產品本身問題

1： Problems with the product itself

預縮工藝不規范或工藝本身有問題

The pre-shrinking process is not standardized or there are problems with the process itself

預縮工藝是指用物理方法減少織物浸水后的收縮以降低縮水率的工藝過程。預縮目的是使織物在經緯向預行一定量的收縮，保持終成品縮水率的穩定，同時也能一定程度增加紡織品柔軟性及手感。

Preshrinking process refers to the process of reducing the shrinkage of fabrics after immersion in water by physical methods to reduce the shrinkage rate. The purpose of preshrinking is to make the fabric undergo a certain amount of shrinkage in advance in the warp and weft directions, maintaining a stable shrinkage rate of the final product, while also increasing the softness and feel of the textile to a certain extent.

紡織品未達標準

Textiles not up to standard

對于生產不規范的布草供應商，存在“以次充優”現象，將40S產品代替60S產品銷售。織物紗支粗細不同，縮水率也不同。紗支粗的布縮水率越大，紗支細的織物縮水率越小。

There is a phenomenon of "inferior to superior" among linen suppliers who produce non-standard products, and they sell 40S products instead of 60S products. The shrinkage rate of fabrics varies with the yarn count thickness. The larger the shrinkage rate of fabrics with coarse count, the smaller the shrinkage rate of fabrics with fine count.

熱定型未做好

Heat setting not completed

熨燙過程中出現縮水，一般由于紡織品在生產過程中熱定型未做好。具體表現為：同一方向的熨燙時，面料的經向或緯向收縮，造成縮水。

Shrinkage occurs during ironing, usually due to the fact that the textile is not properly heat set during production. Specifically, when ironing in the same direction, the fabric shrinks in the warp or weft direction, resulting in shrinkage.

二：洗滌原因：

2： Washing reason:

新布草洗滌溫度過高

New linen washing temperature too high

溫度對于布草洗滌來說是至關重要的，新布草初次洗滌溫度不宜超過90°C。改善建議：在過水過程中不添加任何洗滌劑或只添加主洗劑，洗滌溫度建議在70°C-80°C之間。

Temperature is crucial for cloth washing, and the initial washing temperature of new cloth should not exceed 90 ° C. Suggestions for improvement: Do not add any detergent or only add the main detergent during the water passing process, and the washing temperature is recommended to be between 70 ° C and 80 ° C.

烘干溫度過高

Drying temperature too high

烘干溫度超過95°不僅會造成縮水，還會導致纖維脆化、布草發黃等問題。以毛巾為例，正確烘干溫度保持在75°C左右，干燥后需再冷卻到5-10分鐘，冷卻溫度到50°左右。

Drying temperature above 95 ° will not only cause shrinkage, but also lead to fiber embrittlement, fabric yellowing, and other issues. Take the towel as an example. The correct drying temperature should be maintained at around 75 ° C. After drying, it should be cooled to 5-10 minutes, and the cooling temperature should be around 50 ° C.

熨燙溫度過高

Excessive ironing temperature

熨燙溫度是影響熨燙效果的主要因素。如果熨燙溫度過高，超過面料允許受熱溫度，面料易燙黃、燙焦、變形；熨燙溫度過低，雖不損傷面料，但達不到熨燙效果。一般來說，純棉面料熨燙溫度不宜超過180°。

The ironing temperature is the main factor affecting the ironing effect. If the ironing temperature is too high, exceeding the allowable heating temperature of the fabric, the fabric is prone to yellowing, scorching, and deformation; The ironing temperature is too low, which does not damage the fabric, but does not achieve the ironing effect. Generally speaking, the ironing temperature of pure cotton fabrics should not exceed 180 °.

酒店布草的參數規格應考慮縮水率或者預計的洗后尺寸。產品在下完整訂單之前，應在酒店洗衣房測試產前樣。通常經過6次洗滌程序，產品會達到終洗后尺寸。

The parameter specifications for hotel linen should take into account shrinkage or the expected size after washing. Pre production samples should be tested in the hotel laundry before placing a complete order. Generally, after six washing procedures, the product will reach the final washing size.

采購大貨，需要對品質的全流程把控，綜合考慮產品的規格參數和內在產品質量指標，做好棉織品的維護和保養，創造良好的洗滌外部環境，強化細節管理，才能夠使布草在正常壽命內大程度的發揮使用性能。更多相關事項了解就來我們網站http://m.xcnmpx.com咨詢吧！

To purchase large goods, it is necessary to control the entire process of quality, comprehensively consider product specifications and internal product quality indicators, properly maintain and maintain cotton fabrics, create a good external environment for washing, and strengthen detailed management. Only in this way can cloth grass maximize its performance during its normal life. For more information, please visit our website http://m.xcnmpx.com Consult!